Trim Enabler and 10.7.3

Trim Enabler and 10.7.3
February 3, 2012 Oskar

If you get your Trim disabled by installing 10.7.3 update, just use Trim Enabler to re-enable. It works just fine in 10.7.3. Trim Enabler will patch your new kext. If you don’t lose support, then you are fine and you don’t need to do anything 🙂

Also, I discovered a “bug” with Trim Enabler 2.0, you can’t launch the app from the .DMG, if you do, nothing will happen when you use the slider. This is because Trim Enabler can’t get permissions from within the DMG. I will make so next version gives you a message to pull the app out of the DMG before you use it.

Comments are disabled. Please continue the discussion in the Forum.
Showing legacy comments below.

2 Comments

  1. TrimLover 8 years ago

    Reinstalled 10.7.3 and that seemed to fix it!

  2. TrimLover 8 years ago

    (I could not re-enable TRIM after 10.7.3 update… so I repaired disk perms and reinstalled 10.7.3.. now im back in TRIM-town!)